Given that every builder has different skill levels and probably no two Maxes emerge as identical twins, when finishing up the controls in the cockpit relative to aileron actuation, it seems that the target becomes getting the two cables attached such that the same amount of inner cable is exposed to view but this amount of cable exposed to view is less than what is exposed to view on the other end(outer). On mine, I think the total cable movement available is approximately 3", when attached to the interior aileron control horn, I have about 1 5/16" of exposed inner cable on each side and slightly more than that on the outside. When the aileron is moved, the cable on one side moves the 1 5/16" but the outer exposed cable on the other side extends to the full length, so differential aileron activation is indeed occurring. So when setting things up on the inside of the cockpit, it seems the target is to get the exposed amount the same on both cables but it will not be one half of the total, which is 3" in my case. There will be slightly less cable visible on both inside cables, slightly more on both outside cables, and both cables will move slightly more when going out, which is moving the aileron up, than the opposite one will move in when moving the opposite aileron down. I think I understand this and I think I presented it correctly here. Thanks. Kim Brown |